Shelly Motion - disponibile da Aprile 2021 Wireless White

Product Information

Reveal the full potential of Shelly Motion by combining it with other devices from your home network. Set Shelly Motion to activate custom scenes based on hour, light, or various actions If Shelly devices are in a different subnet than the Home Assistant server, you should ensure communication on UDP port 5683 between these subnets. Green brief flash: Unreported motion detection (the Device is not connected, or motion detection is disabled).

Using the homeassistant.update_entity service for an entity belonging to a battery-powered device is not possible because most of the time these devices are sleeping (are offline). If you choose to use the Device with the Shelly Cloud mobile application and Shelly Cloud service, instructions on how to connect the Device to the Cloud and control it through the Shelly App can be found in the Shelly Smart Control Guide. Shelly Motion2 isn’t just about motion. It brings the most important metrics to your automation: motion, light levels, vibration and temperature. One could argue that humidity would be nice, but honestly – I’m excited as is. If the BUTTON TYPE of the switch connected to the device is set to momentary or detached switch, the integration creates an event entity for this switch. You can use this entity in your automations. Event entities (generation 2) Shelly® devices can be accessed, controlled and monitored remotely from any place where the User has internet connectivity, as long as the devices are connected to a Wi-Fi router and the Internet.Thanks to these parameters your sensor will only report when predefined thresholds had been reached. On top of that, you can set the operating modes to work at night or day increasing the battery life of the device. Vibration If you think your Shelly devices are working correctly and don’t want to change your network/configuration, you can ignore the repair issue. Still, you must know you are giving up the best experience of using first-generation Shelly devices with Home Assistant.

Set the motion detection threshold (from 1 to 256) using the slider. A lower value sets higher sensitivity. See motion detection percentage above of the slider as you move it. The Device can be managed and controlled through its embedded web interface too. Make sure Shelly Motion 2 is in AP mode. Open the Device Web interface at http://192.168.33.1 when connected directly to the Device access point. ATTENTION! Before beginning the installation, please read carefully and entirely this guide and any other documents accompanying the device. Failure to follow the installation procedures could lead to malfunction, danger to your health and life, violation of the law or refusal of legal and/or commercial guarantee (if any). Shelly Europe Ltd is not responsible for any loss or damage in case of incorrect installation or improper operation of this device due to failure of following the user and safety instructions in this guide. Introduction to Shelly® It’s pretty sensitive at low settings, and I could imagine this can be activated by passing lorries outside if your walls are prone to movement like this. With a bit of trial and error, you could use this to create an earthquake alarm, in case you sleep as deep as me. Shelly app If Channel Name is set to the default value, the integration will use the Device ID and default channel name to generate the entities’ name, e.g. ShellyPro4PM-9808D1D8B912 switch_0.

Smart Scheduling

Input the number of consecutive movements (from 1 to 4) for the sensor to detect before reporting motion. This document contains important technical and safety information about the device, its safety use and installation. IMPORTANT: If the motion sensor detects movement while the Device is in AP mode the LED indication will briefly change to cyan. When motion is detected in any of the conditions below, the sensor will send a separate command when it disappears. The sensor will transmit a new movement after the blind time has elapsed after the last movement.